Insta360 Electric Suction Cup Mount
$67.39
$130.74
Insta360 Electric Suction Cup MountFilm your own road movie. Drive with confidence.Electronic pump automatically removes air with a built-in sensor for strong, steady suction. Rigorously tested to handle bumpy off-road drives and winding mountain adventures. Under lab conditions, the suction cup can achieve a maximum holding force of 50kg when attached vertically to a flat surface, and maintain a minimum holding force of 30kg during continuous use. One-touch suction.Press once and the mount locks instantly. The sensor keeps checking suction strength so your camera stays safe while you keep your eyes on the road. Stick once, shoot all day.Long-lasting battery offers up to 120 hours* of power with up to 5 days of suction on a full charge—ideal for road trips. *Run time based on the mount refreshing its suction once every hour. Actual run time may vary depending on the smoothness of the surface and intensity of vibrations. Shoot from any angle.Double ball head rotates a full 360 degrees to nail any angle from your roof, hood or trunk. Compatible with Insta360 Ace, X and GO Series cameras. In the Box1x Electric Suction Cup Mount1x Protective Cap1x Clamp Mount1x 1/4″ to Ball Head Adapter1x 3-Prong to Ball Head Adapter1x NATO Rail Mount1x Hex Wrench1x Thumb NotesDo not drop, hit, or throw the mount to avoid damage.Do not use the mount in the rain.Do not expose the product to grease or chemical solvents for a long period, as this may weaken the suction.Before installing the mount, ensure that the surface of the car or area is smooth and clean.Before starting suction, press the mount fully against the surface and adjust the angle if neededKeep the white filter cotton at the bottom of the suction cup to prevent sand or dirt from enteringWhen not charging, keep the USB-C ports silicone plug sealed to prevent water or dust from enteringClean the suction cup after use to maintain suction power. When attached to a vehicle, check the battery level while the vehicle is parked. If the battery is below 10%, remove and charge fully before using it again. It is suggested to gently shake the suction cup every 6 hours to ensure it remains secure.If the mount is not used for a long time (e.g., 3 months), recharge the battery.Please assemble and use the Suction Cup Mount according to the instructions above and do not use it with any other accessories, such as a selfie stick. If malfunction or damage is caused by failure to follow the instructions in this document, the warranty will be void.
Dji Osmo Pocket 3